Xhorse Dolphin XP-005 Cutter and Probe Installation and Uninstallation
Xhorse Dolphin XP-005 Cutter and Probe Installation and Uninstallation.
Installation steps:
1)Put the cutter Into the cutter mounting hole and push the cutter to the limit. Then drop the cutter 2-5 mm down. When the screw is perpendicular to the notched part of the side of the milling cutter, the locking screw and the fixed milling cutter.
2)Push the probe into the probe mounting hole and the tip of probe need to be
higher than the tip of cutter .Turn the 'probe locking screw' clockwise until the probe is locked.
Comments
Post a Comment