How to update Xhorse Dolphin XP-005?


How to update Xhorse Dolphin XP005? Here are three methods to get the update package.


Method 1: Contact your distributor and ask for “Upgrade Kit”

Method 2: Send an email titled “Update tool” to support@xhorse.com

Method 3: Consult with online customer service on Xhorse App.

Source:  Xhorse "Upgrade Kit" Download: http://www.xhorsetool.com/info/software-download/

Steps to update both Dolphin XP-005 database and firmware with update package:

Step 1: Connect the Dolphin with a computer through USB cable

Run “Upgrade Kit”

Click “Find Device”


Step 2: The connected device will be recognized and shown on left corner.



Step 3: If the device cannot be found, follow the tips on screen and click “YES” to install driver



Step 4: Select DOLPHIN 1 and install driver


Step 5: When the dolphin machine is found, click “Upgrade”



Step 6: It takes a few minutes to complete upgrading. Please make sure the USB cable is always well connected when upgrading.



Comments

Post a Comment

Popular posts from this blog

Copy BMW HU92 Key: Done by Xhorse XP-005 Plus Keytool Max

Image
How to: Copy a BMW HU92 key by Xhorse Dolphin XP005 and Key tool Max? Preparation: Dolphin XP-005 auto key cutting machine Xhorse VVDI Key Tool Max Original BMW HU92 key + Blank key Procedures: Connect Key tool max with Dolphin XP005 via Bluetooth Enter Dolphin XP005 main menu Select the corresponding car make, model and key type Follow the instruction to put the working key to the XP005 cutting machine Decode key When finish decoding, put the new key to cut both sides Finally, test the keys Source: http://blog.xhorsetool.com/dolphin-xp005-plus-key-tool-max-cut-bmw-hu92-key/
Read more

How to adjust the machine parameter on Xhorse Dolphin XP-005

Image
How to adjust the machine parameter on Xhorse Dolphin XP-005 auto key cutting machine ? Here is the step-by-step operation guides, incl. Height level adjustment, clamp calibration and cutting calibration. Check the steps as follows. How to adjust height level on Xhorse Dolphin XP-005? Step 1: Enter Dolphin XP-005 operation main interface and on “Machine Parameter”  Step 2: Select “Height Level Adjustment” Step 3: Adjust the heights of cutter and probe by following the tips on the screen, then click on “Start” Step 4: After the machine has stopped, adjust the points of probe and cutter to the same level by following the tips on the screen. Then click on “Continue” Step 5: After the machine has stopped, select the diameter of the installed cutter, click on “Setting cutter diameter” for finish height level adjustment How to calibrate clamp on Xhorse Dolphin XP-005? Step 1: Open Dolphin XP-005 operation main interface Select “Machine Parameter”-> “Clamp Calibration” Step 2: C...
Read more